|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Jeti Receivers, Central Boxes, Transmitters & Sensors ALL IN STOCK!!!
|
|
|
|
|
|
|
|
|
|
Introducing New 2.01 Update for Elite Brushless ESCs with Added Helicopter/Governor Functionality!!! The Ultimate Solution for High Pole Outrunner Brushless Motors Like Xpwr/Scorpion/Xnova (Tested up to 42P) with Advanced Features Like Active Freewheeling, Prop Positioning, Automatic Cooling & Much More!!!
The brand new line of Elite Falcon Opto & SBEC ESCs target mainly professionals and pilots looking for uncompromising precision and quality. The Elite Falcon ESCs combine new revolutionary design, system upgradability, almost unlimited flexibility with state of the art telemetry capabilities.
- Set the minimum and maximum RPM of the main rotor according to your preferences. As soon as you move the throttle away from idle position, the controller slowly spools up until it reaches the target speed. The speed is calculated according to the throttle channel value, where low throttle corresponds to the "Minimum Rpm" and high throttle corresponds to "Maximum Rpm."
- Set the Spool up Time to make the motor startups as smooth as possible. You may set the time up to 60s. The spoolup time is applied when the motor starts from zero revolutions or if the autorotation bailout is disabled.
- Configure the Autorotation bailout time and autorotation acceleration time. The autorotation bailout function is used in case you need to quickly exit the autorotation and prevent your model from crashing. In this case, as soon as you move the throttle channel away from idle position, the "Autorotation acceleration" will be used to spin the motor until it reaches the required speed. The “Autorotation bailout” parameter sets the time after switching off the motor, where the autorotation bailout function may be activated. After exceeding this time, a standard spool-up time will be applied.
- Advanced setting: Governor gains - (P)roportional and (I)ntegral. You may modify the gains to fine tune the controller response to fast changes in the load during flight maneuvers. Please perform the changes only in small steps and verify the resulting behavior in a short test flight.
- In the Governor mode, manual throttle endpoints are always used (by default 1.1ms - 1.9ms) and Active braking is enabled as well.
The picture below shows RPM response vs. throttle position. In this case, default throttle endpoints have been used (1.1ms - 1.9ms).
|
|
|
|
|
|
|
|
|
|
Elite Electronic Receiver Power & Ignition Kill Sliding Touch Switches with Incredible Low Standby Current (0.05mAh)!!! (Yup We Did It Again)!!!
The Elite Sliding Touch Switch is an electronic device that can be used to turn ON and OFF the electronics in your RC model. It can replace any electronic or mechanical switch. Features configurable touch sensitivity, last power-on status is stored in the internal memory, and very low standby current.
You do not need any additional tools to power up your model (such as a magnet in the case of a magnetic switch). The advantage of an electronic switch is that it offers a virtual unlimited ON/OFF cycle, unlike mechanically operated switches.
The faceplate contains an integrated LED to indicate the ON/OFF status of the switch. Should any of the devices become disconnected from the switch, the device will stay ON and switch will remember its last state.
|
|
|
|
|
|
|
|
|
|
Spring Cleaning: AP Model ASK 13, ARC (Almost Ready to Cover) 3.2m Scale Sailplane (Last One Left, Only $575.00)!!!
|
|
|
|
|
|
|
|
|
|
TopModel Samsara 3.2E, Albatros Classic 3E, Prelude 2.5E REF, Albatros 2.4E & Super Sport 2.35E Electric Sailplanes Ready for the 2023 Season !!!
|
|
|
|
|
|
|
|
|
|
StandBox is a Light Flexible Modular System Used for Building, Maintenance, Transport, and Storage of R/C Model Airplanes.
|
|
|
|
|
|
|
|
|
|
|
|
|